INSTALLATION INSTRUCTIONS
Step 1. Clean, Hold in Place and Cut to Length
Thoroughly clean surface the table edge guard will be positioned on ensuring any wax, polish or oil is removed. Wipe over with isopropyl alcohol.
Then, trim Edge Armor with scissors to appropriate length. (it is recommended to apply corner guards first before trimming table edge guard). Also note do not stretch edge guard when measuring as it can ‘retract’ later leaving a small gap.
Step 2. Fix the Double Sided Tape to Surface
Stick equal length of double sided tape to the surface as close to the edge as practical, both on the top and if able and required the side edge.
For corner protectors, apply double sided tape to the foam first.
Peel back double sided tape top cover.
Step 3. Stick and Hold Edge Armor In Place
Carefully place the table edge guard, or corner protector into place.
Press firmly and hold for 30 seconds at ends.